- Positive setting of the diamond to absolute center with the special gage included with the dresser
- Simple,fast,accurate radius setting; no height gage or other set-up aids required. Radius is set on the ginder by measuring over the two pins or by inserting a gage block,as shown, for direct reading. Inside or outside radius is determined simply by sliding the dowel pin to the right for concave and to the left for convex.
- 4×90° gaduation in full 360° circle. 6 Minute vernier reading. Chrome plated.
- One push-pull type knob for radius and angle control and for safer and faster operations.
- ACCURACY. Exteremely close tolerances are held in the manufacture of this tool, assured by hardening and precision grinding of all critical parts. Ways are chrome hardened.
- ECONOMY. Set-up and dressing time reduced to a bare minimum due to simplicity.
- Made in Taiwan
Specifications:
- Maximum Wheel Diameter Standard: 10"
- Internal Radii: 5/8" - 1-5/8"
- Extrenal Radii: 0 - 1-5/8"
- Height from Base to Center: 4-3/32"
- Tangent Travel, either side of center: 1-5/8"
