Sharp Industries 9" x 49" Table Vertical Knee Mill - LMV-49DVS
These vertical knee mills are equipped with vari-speed drive. The dove tail ways chromed, and the box ways are hardened and ground.
ISO 9002 Certified:
Quality Up To World Industry Standards.
Meehanite Casting:
Highest Grade Of Casting Possible.
A Pair Of Precision ABEC-7 Angular Contact Bearings To Support Spindle. The Quill Is Ground And Chromed To Fit The Housing:
This Insures A Spindle Run out Of .0002” T.I.R.
Motor Shaft And Varidrive Pulleys Are Dynamically Balanced, Then Chromed For A Flawless Fit, Ground Ribs On Inside Diameter:
For Smooth Speed Changes.
Motor Shaft Has An Oil Channel In The Center That Is Fed By A Grease Fitting On The Lower End:
To Keep Vari-Drive Pulley Moving Smoothly On The Shaft.
This LMV-49DVS Mill Uses A Roller Bearing For The Lower Support Of The Shaft: It Ensures Proper Loading, Support And Alignment It Also Prevents The Shaft From Being Distorted By The Tension Of The Belt:
For Quiet, Accurate Operation At Any Speed For Years And Years.
One Shot Lubrication System:
For Lubrication Of Ways And Lead Screws. (X,Y And Z-Axis)
Hand Scraped Saddle And Knee:
For Better Oil Retention. It Avoids Having Chips And Dirt Embed In The Knee And Damage The Sliding Surface.
Oil Groove Are Milled:
For Maximum Lubrication On All Wear Areas.
Table And Saddle Backlash Is Controlled By Double Nut Design:
Keeps Lead Screw In Contact With Bronze Nuts An All Times To Keep Backlash At .0008” Within 20”.
Table And Saddle Are Mounted With Thrust Bearings That Are Pre Loaded:
Eliminating Endplay For Precisely Controlled Lateral Movement.
Patient Knuckle Design Uses 6 Bolt 3 Per Side, Securing Them From The Outside:
This Method Locks The Head Securely Resulting In Better Accuracy And Performance.
STANDARD ACCESSORIES:
- DVS Head
- Hard-chromed ways
- Precision Ground and Flaked Table
- Unique Double Nut Backlash System
- Double Fan Cooling System
- Cutler Hammer On/Off Switch
- One-shot lube system
- Front and rear rubber way covers
- Tool kit
OPTIONAL ACCESSORIES:
- Call for pricing.
- 440 V Transformer - 3HP
- Auto Lube Pump w/ 2 adjustments
- 6" Kurt Vise with Swivel Base D688
- Righ Angle Milling Attachment with Arbor
- Drill Chuck & Drill Arbor
- Coolant system with chip pan
- Maxi Torque Rite Power Draw Bar
- Riser block (4”, 7”)
- R-8 Collet Set of 11 (1/8"-3/4" by 1/16")
- Clamping Kit
- Halogen work light
- Spare Kit
