DS10-4S 4″ x 36″ sanding belt, Combination Sander, 10″ Disc

Great for fast deburring, polishing. Direct drive from double shaft motor.

The 4″ belt can be used vertically or horizontally by rotating the sander frame on the C face motor. Cast iron frame with platen for getting your parts flat! Steel tilting disc work table tilts down 45 degrees and 90 degrees at the disc. The 4″ belt work table is 5″ x 2.5″ and can be tilted up 35 degrees and down 45 degrees.  Fast sanding belt tracking and belt removal. 

• 10″ disc sander with 4″ x 36″ belt sander.
• With full boxed OSHA guard, Horizontal or vertical belt position.
• 1/2 HP 1PH TEFC motor , 115 volts, 1 ph, 7.4 amps, 230 volt, 1 ph, 3.7 amps.
• Factory wired at 115 volt, 1 phase, 8 ft. 3 prong plug standard.