The A series of Industrial Drilling Machines are capable of handling heavier workpieces with a wide range of drilling and tapping capacities. Designed for easy operation with a mechanical clutch for precise automatic feed control that can be activated from the feed crank handle or by the lever on the front of machine head.
Standard Features and Equipments:
-
Drilling capacity in steel: up to 1.97" (50mm) maximum
-
Drilling capacity in cast iron: up to 2.36" (60mm) maximum
-
Tapping capacity in steel: up to 1.42" (36mm) maximum
-
Tapping capacity in cast iron: up to 1.65" (42mm) maximum
-
Automatic feed reversing system for tapping on “RS” models
-
Automatic feed and cut-off by mechanical clutch
-
Hardened and ground high quality steel gears
-
Speed plate and selecting levers on front of head
-
Gear box lubrication by automatic pump
-
Machine base with 2 T-slots, coolant tank and pump
-
Large rotating table with 3 T-slots
-
Feed crank wheel for manual feed
-
Front hand wheel for fine feed work
-
Depth scale andadjustable depth stop
-
Automatic tool ejector
-
Work Light
-
Built-in low voltage electrical equipment in machine head
-
Emergency STOP
-
Drill guard with microswitch
-
Rotating table and tilting support
-
Automatic pitch control tapping with single speed brake motor
-
Automatic pitchcontrol tapping with pneumatic rapid approach
-
Master guide spindle and nut set for automatic pitch control tapping
-
50% lower feed range
-
Mechanical spotface device
-
Pneumatic counterbalance
-
Multi-spindle head guide rod
-
Union, dragging cone and assembly for multi-spindle head
-
Multi-spindle head guide rod
-
START-STOP and emergency STOP pendent control
-
8" column riser
-
Cross slide table
-
Cycle start foot pedal
-
Foot pedal for reversing
-
Worklight with magnetic base
-
Coolant system with independent container