Baileigh SH-6014 Hydraulic Sheet Metal Shear, 14ga x 60" - BA9-1007176

At a blistering 30 strokes a minute for 14 gauge mild steel the SH-6014 will save you time and money on your next metal shearing project. The SH-6014 metal shear uses 60" blades that can cut down to 14 gauge mild steel or 18 gauge stainless steel easily.

This machine is made of fully integrated and welded steel plate allowing enough rigidity to shear at full capacity all day long. Powered by a 3hp 220 volt three phase motor, the industrial hydraulics pull the top blade smoothly through the material being cut increasing blade life. This metal shears top and bottom shearing blades have multiple cutting edges that extend blade life. The SH-6014 also has a hold down carriage with 9 fingers hold the sheet metal firmly against the in feed table eliminating any lifting of material as it is cut, again this improves blade life.

The SH-6014 hydraulic metal shear has a manual back gauge as well as front support arms to help the operator handle the sheet metal and provide for repeatable shearing. The operator control panel has a switch that allows the fabricator to jog the blade, do one cycle or cut, or go into an automatic mode that is initiated by the foot pedal control.

At a blistering 30 strokes a minute, this hydraulic shear will save you time and money. Made of fully integrated and welded steel plate, the SH-6014 can run at full capacity all day long.

• 60" length.
• 14 gauge mild steel maximum capacity.
• Minimum capacity of 24 gauge mild steel.
• 3 hp motor runs on 220-volt 3-phase power.
• Adjustable 24” backgauge ensures precise repeatability.
• Front support arms and table guides keep the material square to the blade.
• 3 modes on the operator console:
  • Inch mode: Jog the control and ease the blade down to the material.
  • Single mode: Make one cut cycle per foot pedal push.
  • Auto mode: Continue cycling as you hold the pedal down.
• Comes standard with high carbon chromium blades.
• Blades have 4 shearing edges, so you can turn them when an edge gets dull to extend blade life and save money.
• Hold-down carriage with 9 fingers clamps the sheet metal firmly against the infeed table, improving blade life.
• Rigid, fully welded steel plate construction helps prevent flex and gives you many years of accuracy.
• Covered by a 1-year parts warranty.
• Baileigh stocks replacement parts, including blades, at their warehouse for fast shipping.
• Includes lifetime technical support by phone from Baileigh's team of reps with hands-on metalworking experience.

Specifications: